MAINTENANCE
CAUTION
Before performing wheel or brake maintenance,
Erify that the main switch is in the "OFF" position.
Wheel Replacement
To remove and install a wheel on your golf car:
1. With the wheels blocked to prevent the golf
Car from moving loosen the wheel nuts .
2. Elevate the golf car with a jack and remove
The wheel nuts and the wheel.
3.Reverse the removal steps when installing the wheel.
Brake Adjustment
The brakes on your golf car are self-adjusting .
Before you operate the car, press down on the brake pedal
Several times to make sure the brakes are functioning properly.
WARNING
Consult our company staff before using your golf car
If you suspect brake problems brake Failure could result.
Brake Pedal Free Play Adjustment
CAUTION
Before adjusting brake pedal free play ,
Pump the brake pedal several times to self-adjust the brakes .
To adjust the brake pedal free play :
1.Remove the service lid from the floor of the golf car
2.Check the brake pedal free play by pressing against
The pedal with two fingers (using light force ) and measuring
The distance the pedal travels before resistance is felt.
3. If the free play distance needs adjusting ,loosen
The lock nock nut and turn the adjusting nut in or out until
The free play specification is met.
Then tighten the lock nut in place
WARNING
Do not overtighten the brake cables.
The self adjusters may not operate properly,
Reducing braking perforrmance.
STORAGE
Perform the following preparations when storing your golf car for extended periods of time:
NOTE:
Turn main switch key to "OFF" posItIon remove key, and store key in a safe place.
CHASSIS PREPARATION
1.Veri fy the tire pressure is set to 20psi(137 kpa, 1.4kgf/cm2)
2.Clean exterior of the golf car and apply a rust inhibitor.
3.Cover the golf car with a breathable cover and store it In dry, well-ventilated.
BATTERY PREPATION
1.Recharge the batteries and check the fluid levels at least once month.
CAUTION
Do not allow cleaning solution to enter battery cells.
2.Clean the tops of the batteries with a solution of baking soda
And water, as necessary, to remove corrosion.
SPECIFICATIONS
TRANSMISSION
BATTERY
SPECIFICATIONS
CHASSIS
CHECK LIST FOR USERS









